"

Lab #4 : Code for DELAY

image

This report requires you to write down the assembly code for delay (use the delay code with the blinking LED program). Use the following instructions:

  1. Blinking LED code available from the lecture below for your review
  2. Make the block diagram for the delay code which explains the algorithm you used
  3. Based on the algorithm create an assembly code to provide a delay
  4. Once the Delay code is created then add it to the existing blinking LED code from the lecture
  5. Write a report stating the whole process, the difficulty, and tips you found in that process.

License

Icon for the Creative Commons Attribution 4.0 International License

Introduction to Microcontrollers Copyright © 2024 by Lake Washington Institute of Technology is licensed under a Creative Commons Attribution 4.0 International License, except where otherwise noted.