Primary Navigation
Want to create or adapt books like this? Learn more about how Pressbooks supports open publishing practices.
Book Contents Navigation
Introduction
Cary Flanigan
1. Chapter 1: The Language of Lines
Ric Costin
2. Chapter 2: How to Learn to Read Blueprints
3. Chapter 3: Acronyms in Welding
4. Chapter 4: Basics of Welding Symbols
Cameren Moran
5. Chapter 5: Fillet Weld Symbols
6. Chapter 6: Groove Welding Symbols
7. Chapter 7: Pipe Symbols
8. Chapter 8: Edge Weld Symbols
9. Chapter 9: Plug Weld symbols
10. Chapter 10: Joint types and Terminology
11. Chapter 11: Scaling
Lisa Hillyard
12. The Basics of Fractions
Chad Flinn and Mark Overgaard
13. Adding and Subtracting Fractions
14. Multiplying Fractions
15. Dividing Fractions
16. Fractions Quiz
17. Understanding Decimal Notation
18. Compare and Round Decimals
19. Convert Decimals to Fractions
20. Convert Fractions to Decimals
21. Decimals Quiz
Appendix C: Credits
Outcomes
Previous/next navigation
Basic Blueprint Reading for Welders Copyright © 2023 by Cary Flanigan is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License, except where otherwise noted.